Daikin Altherma 3 H HT - Page 31

5 | About the units and options
Installer reference guide
31
EPRA14~18D + ETVZ16S18+23E
Daikin Altherma 3 H HT F
4P644739-1A – 2022.03
INFORMATION
▪ The remote indoor sensor can only be used in case the user interface is
configured with room thermostat functionality.
▪ You can only connect either the remote indoor sensor or the remote outdoor
sensor.
Remote outdoor sensor (EKRSCA1)
By default the sensor inside the outdoor unit will be used to measure the outdoor
temperature.
As an option the remote outdoor sensor can be installed to measure the outdoor
temperature on another location (e.g. to avoid direct sunlight) to have an
improved system behaviour.
For installation instructions, see the installation manual of the remote outdoor
sensor and the addendum book for optional equipment.
INFORMATION
You can only connect either the remote indoor sensor or the remote outdoor sensor.
PC cable (EKPCCAB4)
The PC cable makes a connection between the hydro PCB (A1P) of the indoor unit
and a PC. It gives the possibility to update the hydro software and EEPROM.
For installation instructions, see:
▪ Installation manual of the PC cable
▪ "10.1.2To connect the PC cable to the switch box"[4126]
Heat pump convector (FWX*)
For providing space heating/cooling, it is possible to use the following heat pump
convectors:
▪ FWXV: floor-standing model
▪ FWXT: wall-mounted model
▪ FWXM: concealed model
For installation instructions, see:
▪ The installation manual of the heat pump convector
▪ The installation manual of the heat pump convector options
▪ The addendum book for optional equipment
WLAN module (BRP069A71)
A WLAN cartridge (to be plugged into the MMI) is delivered as indoor unit
accessory. Alternatively (e.g. in case of weak signal strength), you can install the
optional wireless LAN module BRP069A71.
For installation instructions, see the installation manual of the WLAN module and
the addendum book for optional equipment.
Universal centralised controller (EKCC8-W)
Controller for cascade control.
Human Comfort Interface (BRC1HHDA) used as room thermostat
▪ The Human Comfort Interface (HCI) used as room thermostat can only be used in
combination with the user interface connected to the indoor unit.