Daikin Altherma 3 H MT W - Page 222

10 | Configuration
Installer reference guide
222
EPRA08~12EAV3+W1 + ETBH/X12EF6V+9W
Daikin Altherma 3 H MT W
4P634885-1 – 2021.03
a WLAN module The WLAN module needs to be installed by the
installer on the indoor unit (on the inside of the
front panel). See:
▪ Installation manual of the WLAN module
▪ Addendum book for optional equipment
b Router Field supply.
c Smartphone + app The Daikin Residential Controller app needs to be
installed on the user's smartphone. See:
http://www.onlinecontroller.daikineurope.com/
Configuration
To configure the Daikin Residential Controller app, follow the in-app instructions.
While doing this, the following actions and information are needed on the user
interface of the indoor unit:
Mode: Turn AP mode ON (=WLAN module active as access point) or OFF.
# Code Description
[D.1] N/A Enable AP mode:
▪ No
▪ Yes
WPS: Connect the WLAN module to the router.
# Code Description
[D.2] N/A Connect to home network:
▪ Back
▪ OK
Reboot: Reset the WLAN module.
# Code Description
[D.3] N/A Reboot the gateway:
▪ Back
▪ OK
Device info: Consult information about the WLAN module.
# Code Description
[D.4] N/A Device info:
▪ SSID
▪ MAC address
▪ Serial number
INFORMATION
Restriction: WLAN settings are only visible when a WLAN cartridge is inserted in the
user interface.