Field Setting ESIE09-08B
96 Test Operation
[7] Option setup
[7-00] Bottom plate heater option
An optional bottom plate heater can be installed in your outdoor unit. In case an ERRQ*
outdoor unit (special model with freeze-up countermeas
ures) is installed, the unit will have
the bottom plate heater already standard installed.
If the bottom plate heater is installed, its operation must be enabled by field setting. Default
[7-00] = 0 which means no bottom plate heater is installed. Set [7-00] to 1 if the bottom plate
heater is in
s
talled.
[7-02] Select multiple set point pattern A or B
Multi set point control according pattern A
During normal operation, domestic water heating and space heating modes are
separated
and activated intermittent to fulfil a simultaneous request. Therefor multiple set
point pattern A can be configured to allow simultaneous domestic water and space
heating without intermission.
Multi set point control according pattern B
The basic setup of multiple set point pattern B is the same as a normal classic design, so
AGAIN
no domestic water heating and
space heating is possible simultaneously. Multiple
set point pattern B is focussed on space heating operation and allows using multiple
water set points in combination with the remote controller or external room thermostat.
The configuration of pattern B allows space heating set points and the domestic hot
water set point.
[7-03] Activation for multiple set point 1
[7-04] Activation for multiple set point 2
First
code
Second
code Setting name
Default
value Range Step Unit
7 Option setup
00 Optional bottom plate heater installed 0
(OFF)
0/1 — —
02 Mult
iple set point pattern 0 (A) 0/1 — —
03 Multiple set point 1 0
(OFF)
0/1 — —
04 Mult
iple set point 2 0
(OFF)
0/1 — —
To Next Page
Loading...
