Daikin Altherma HT - Page 125

ESIE09-08B Field Setting
Test Operation 113
The numbers in the "No." column represent the number of times to press the
SET (BS2) button.
Note : 8HP not important to change settings.
No. Setting item
LED display
Data display
H1P H2P H3P H4P H5P H6P H7P
14
Contents of malfunction (the
latest)

 
  

Malfunction
code table
Refer to page
128.
15
Contents of malfunction
(1 cycle before)

     
16
Contents of malfunction
(2 cycle before)
      
20 Contents of retry (the latest)
      
21 Contents of retry (1 cycle before)
      
22 Contents of retry (2 cycle before)
      
25
Normal judgment of outdoor units
PC board
c      
Lower 2 digits:
 Abnormal
 Normal
 Unjudgment
c. Monitor mode
<Selection of setting item>
<Confirmation on setting contents>
To enter the monitor mode, push the
MODE (BS1) button when in “Setting
mode 1”.
Push the SET (BS2) button and set
the LED display to a setting item.
Push the RETURN (BS3) button to
display different data of set items.
Push the RETURN (BS3) button and
switches to the initial status of
“Monitor mode”.
∗ Push the MODE (BS1) button and
returns to “Setting mode 1”.
(V2765)