ON/OFF TIMER Operation
To use the ON/OFF TIMER with an hours remaining
display (COUNT UP-DOWN ON/OFF TIMER)
• Check that the clock is correct.
If not, set the clock to the present time.
Page 6
1. Press and hold or for about
5 seconds, when signal indicator ( ) blinks,
release your fi nger from the button.
For ON TIMER
“
” is displayed on the LCD.
“
” blinks.
For OFF TIMER
“
” is displayed on the LCD.
“
” blinks.
• “
” and day of the week disappear from the LCD.
2. Press until the time setting reaches the point
you like.
• Each pressing of the button increases or decreases the time setting by 1 hour.
• The time can be set between 1 and 12 hours.
3. Press or again.
• “ ” or “ ”, and setting time are displayed on the LCD.
• The TIMER lamp lights orange.
• To change the display mode from COUNT UP-DOWN ON/OFF
TIMER to 24 HOUR ON/OFF TIMER, repeat STEP
1, and continue
from STEP
2 of “ 24 HOUR ON/OFF TIMER ”.
Page 13,14
• Timer display mode cannot be changed while “ ” or “ ” are
blinking.
Press
or to stop the blinking.
Display
• Different display modes (24 HOUR ON/OFF TIMER and COUNT UP-DOWN ON/OFF
TIMER) can be used for the ON TIMER and OFF TIMER simultaneously.
(Example)
Present time: 22:00 [unit is in operation]
OFF TIMER at 1:00 (3 hours after present time)
ON TIMER at 6:00 (8 hours after present time)
Combined
NOTE
Notes on COUNT UP-DOWN ON/OFF TIMER
• After setting, the time displayed on the LCD will automatically count down by 1 hour for every 1 hour that passes.
For example, if the OFF TIMER is set to 3 hours, the display will change as follows: 3hr 2hr 1hr blank (OFF)
Switching between ON/OFF TIMER display modes (24 hour clock and hours remaining display)
• When changing timer display modes (from 24 HOUR ON/OFF TIMER to COUNT UP-DOWN ON/OFF TIMER or vice versa), the timer
cancels. The timer must be set again to activate it.
15
TIMER Operation
01_EN_3P477582-2.indd 15 6/14/2017 14:12:49
To Next Page
Loading...
