Daikin CDXP25RVMA - Selecting Operation Mode; Night Quiet Mode; Outdoor Unit Quiet Operation

5
Amulti system has one outdoor unit connected to multiple indoor units.
Selecting the operation mode
When the priority room setting is active
but the set unit is not operating or when
the priority room setting is inactive
Whenmorethanoneindoorunitisoperating,priorityisgivento
therstunitthatwasturnedon.
Inthiscase,settheunitsthatareturnedonlatertothesame
operationmodeastherstunit.
Otherwise,theywillenterthestandbystate,andtheOPERATION
lampwillblink;thisdoesnotindicatemalfunction.
NOTE
Notes on operation mode for a multi system
•COOL,DRYandFANoperationmaybeusedatthesametime.
•AUTOoperationautomaticallyselectsCOOLoperationorHEAToperationbasedontheindoortemperature.
Therefore,AUTOoperationisavailablewhenselectingthesameoperationmodeasthatoftheroomwiththerstunittobeturnedon.
CAUTION
• Normally,theoperationmodeintheroomwheretheunitisrststartedisgivenpriority,butthefollowingsituationsareexceptionstothisrule.
IftheoperationmodeoftherstroomisFANoperation,thenusingHEAToperationinanyroomafterthiswillgiveprioritytoHEAToperation.
Inthissituation,theindoorunitoperatinginFANmodewillswitchtostandby,andtheOPERATIONlampwillblink.
With the priority room setting active
Referto“Priority room setting” on the next page.
NIGHT QUIET mode (Available only for COOL operation)
NIGHTQUIETmoderequiresinitialprogrammingduringinstallation.Pleaseconsultyourretailerordealerforassistance.
NIGHTQUIETmodereducestheoperationnoiseoftheoutdoorunitduringthenight-timehourstopreventannoyancetoneighbours.
• NIGHTQUIETmodeisactivatedwhenthetemperaturedrops6°Cormorebelowthehighesttemperaturerecordedthatday.
Whenthetemperaturedifferencebetweenthecurrentoutdoortemperatureandthemaximumoutdoortemperaturebecomeslessthan4°C,
this function will be cancelled.
• NIGHTQUIETmodeslightlyreducesthecoolingefciencyoftheunit.
OUTDOOR UNIT QUIET operation
FordetailsonOUTDOORUNITQUIEToperation,refertotheoperationmanualincludedwiththeremotecontroller.
When the priority room setting is active but the set unit is not operating or when the
priority room setting is inactive
WhenusingtheOUTDOORUNITQUIEToperationfeaturewithamultisystem,setallindoorunitstoOUTDOORUNIT
QUIEToperationusingtheirremotecontrollers.
WhencancellingOUTDOORUNITQUIEToperation,simplycancelthemodeononeoftheoperatingindoorunitsusingtheir
remote controller.
HoweverOUTDOORUNITQUIEToperationwillremaindisplayedontheremotecontrollersfortheotherrooms.
Werecommendyoucanceloperationinallroomsusingtheirremotecontrollers.
With the priority room setting active
Referto“Priority room setting” on the next page.
Room A Room B
Room C Room D
Outdoor unit
Note for Multi System
Multi Connection
01_EN_3P472684-5A.indd 5 7/3/2017 5:20:07 PM