12
GROUND - LUG
LINE IN VOLTAGE
L1, L2, L3
POWER SUPPLY
GROUND
THERMOSTAT WIRE
THERMOSTAT WIRE
NOTE: CHECK TRANSFORMER
TO MATCH THE CORRECT VOLTAGE
TAP WITH LINE VOLTAGE
RDS
WARNING
Areas Without Convenience Outlet
Install conduit connectors at the designated locations.
10% of the value indicated on the unit data plate. Phase
POWER THRU
THE CURB
RETURN
LOW VOLTAGE
ENTRANCE
HIGH VOLTAGE ENTRANCE
(REMOVE PLUG)
1.
(Refer to the DDC Quickstart Guide)
2. Locate thermostat or remote sensor in the conditioned
device.
3.
4.
through the condenser panel opening or through
5.
To Next Page
Loading...
