17
STARTUP, ADJUSTMENTS, AND CHECKS
WARNING
HIGH VOLTAGE!
CAUTION
Place manifold gage sets on the compressor suction and
should drop and discharge pressure should increase. If
WARNING
MOVING MACHINERY HAZARD!
instructions. If any sparking, odors, or unusual sounds
If horizontal duct is installed, duct covers must be
removed before operating unit.
proper startup of the equipment in the minimum amount of
After the machines are used for
temporary heating or cooling, inspect the coils, fans, and
•
•
•
•
•
•
plate.
the contractor.
Remove any extraneous construction and shipping
all fans manually to check for proper clearances and that
tighten if necessary. Re-tighten all electrical connections.
Verify that all duct connections are tight and that there is no
To Next Page
Loading...
