15
All propane gas equipment must conform to the safety
gas pressure depends on three main factors:
1.
container or containers.
2. Proper pressure regulation.
3.
and total load of all appliances.
Complete information regarding tank sizing for
vaporization, recommended regulator settings and pipe
propane gas suppliers.
standard com mercial compounds, special pipe dope must
®
, Stalactic
®
,
®
®
are satisfactory.
Maximum
Continuous
Second Stage
Regulator
First Stage
Regulator
The gas supply piping location and installation for roof
edition of the National Fuel Gas Code ANSI Z223.1/NFPA
54.
1. Route gas piping to unit so that it does not interfere
align piping to prevent strains or misalignment of the
2.
pipe connections. The size of the gas supply piping
of units on the system, gas characteristics, BTU
National Fuel Gas Code
ANSI Z223.1/NFPA 54.
3. These units are designed for either natural or
the factory for only one of these fuels. The fuels are
the appropriate factory kit (see unit Technical Manual
should attempt conversion. Kit instructions must
operation.
4.
at the unit gas valve. If the gas pressure at the
5.
To Next Page
