Alarm Log Menu
The last fty alarm events (alarm detection and return to
normal) as well as the date and times that they were detected
are displayed on the Alarm Log menu. These alarm events are
displayed in the order that they were detected. The alarm event
that was detected most recently is displayed rst. Multiple
occurrences of the same alarm may appear.
Table 39: Alarm Log Menu
Item Display Name Default Setting Range Password Level
Log Alm Count= — 0–50 None
ClrLog= No
No
Yes
None
+Alarm 1:Alarm Type — None
+Alarm 2:Alarm Type — None
Once an alarm is cleared there will be two entries in the Alarm
Log. A (+) sign will be shown next to the entry added when the
alarm became active and a (-) sign will be shown next to the
entry added when the alarm has been cleared.
Alarm Conguration Menu
The Alarm Conguration menu is also available under the
Commission Unit menu. Refer to page 57.
Analog Input Status Menu
The Analog Input Status Menu provides diagnostic information
to qualied service personnel. The items listed in this menu will
provide current status information of the unit’s analog inputs.
The value shown is the input resistance shown in 1/10th of an
ohm scale. Example: MCB-AI1 (DAT sensor) shows a value
of 181380, the actual resistance would be 18,138 ohms. This
would translate to a temperature of 53.5 ºF.
Table 40: Analog Input Status Menu
Item Display Name Default Setting Range Password Level
MCB-AI1= — 0–99999999 2
MCB AI2= — 0–99999999 2
MCB AI3= — 0–99999999 2
Menu desCrIpTIons
www.DaikinApplied.com 63 OM 920-6 • MICROTECH UNIT CONTROLLER
To Next Page
Loading...
Need help?
General
