Daikin RXYMQ5BVM - Multi-Controller Setup

12
OPERATION
HowtosetMasterRemoteController
• When the right to select the cooling/heating operation mode is set in the master remote controller, “ ” is
displayed in slave remote controllers.
The right to select the cooling/heating operation mode cannot be set in slave remote controllers.
BRC1E62
1,2
• When the system is installed as shown below, it is necessary to designate the master remote controller.
• Only the remote controller having the right to select the cooling/heating operation mode (master remote controller)
can select the cooling/heating operation mode.
One of these remote controllers needs to be
designated as the master remote controller.
When one outdoor unit
is connected with
several indoor units.
Outdoor unit
Indoor unit
• The displays of slave remote controllers show “
” (changeover under master control) and they
automatically follow the operation mode directed by the master remote controller. (This symbol is not displayed in
wireless remote controllers.)
However, it is possible to changeover to program dry with slave remote controller only if the system is in cooling
operation set by the master remote controller.
Setting the master remote controller
01_EN_3P344160-13U.indd 12 06-Oct-20 2:42:06 PM