ED34-862 Accessories
FXFQ-P 89
2
4. INSTALLATION OF SUCTION GRILLE AND SERVICE COVER
(1) Install the suction grille
Install by reversing the procedure shown in “PREPARATION OF DECORATION PANEL”.
It is possible to install the suction grille in 4 directions by turning the suction grille.
Change the direction when adjusting the direction of the suction grille of multiple units or in meeting
customers’ demands.
6 8 Electric
components box lid
Screw
(2 locations)
Indoor unit side
Hooks
Connector
Connect securely
Swing flap motor lead wire
7 Swing flap motor lead wire
Decoration panel side
Loosen the two screws, slide the cover
in the direction of the arrows,
and disengage from the hooks.
<Wiring Diagram>
(The orientation of the indoor unit is changed
for purposes of description.)
Fig. 9
Install the suction grill.
1
Tilt the suction grill at a
45˚ angle and fix 3 hooks
to the decoration panel.
3
Slowly push the suction
grill up and lastly, ensure
the grill is fastened to the
decoration panel body,
keeping pressing 2 knobs.
2
Hook up the strings of the suction grill to the fixtures of the
body corners (2 places) as shown below.
When installing the grill,
change the direction of
the strings.
String
Suction grill
Fixture
Decoration
panel body
Suction grill
String
String
String
Suction grill
Fixture
It should not
hang outside.
NOTE :
Be careful not to get swing flap motor lead wire get caught when installing the suction grille.
NOTE:
When mounting the
suction grill, strings may
be caught in the grill.
Be sure that
strings do not
hang out of the
suction grill edges.
Все каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html
To Next Page
Loading...
