2
7
GENERAL INFORMATION
Manufacturer’s data and machine identication data
The plate shown, which is applied directly to the machine,
provides all the information needed to identify the machine
and the manufacturer.
A) Manufacturer’s details
B) Serial number
C) Year of construction
D) Machine model
E) Number of groupheads
F) Maximum water pressure
G) Maximum coee circuit pressure
H) Maximum boiler pressure
L) Boiler capacity
M) “CE” marking of conformity
N) “EEEW” (RAEE) marking concerning the obligation to
dispose of electrical and electronic equipment sepa-
rately from household waste
P) Electrical connection voltage range and frequency
Q) Electrical power
R) Degree of protection - IP
Technical assistance procedure
In the event of failures or malfunctions, requests for tech-
nical support must be made to the nearest service centre
or directly to the manufacturer.
When requesting technical assistance the data shown on
the identication plate and the type of failure must be re-
ported.
To Next Page
Loading...
