7
56
INFORMATION CONCERNING
HANDLING AND INSTALLATION
Handling and installation safety recommendations
All handling operations must be carried out in compliance
with legislation in force concerning safety in the workplace.
Heed the symbols applied to the packaging.
The type of packing is chosen according to the selected
means of transport and the destination.
All the loading / unloading information is printed on the
packing.
During transport, to prevent sudden movements, secure
the packed machine appropriately inside the vehicle.
Handle the packed machine using a suitable lifting device
with a higher lifting capacity than the actual weight of the
load (as shown in the illustration).
Upon receipt of the machine, check that the packing is
intact.
In the event of damage, contact the manufacturer to agree
on the arrangements to make.
Store the packed machine indoors in an area with tem-
peratures that will not go below freezing.
Dispose of the TERTIARY PACKAGING components in
compliance with current legislation on sorted waste col-
lection and disposal and on the basis of the environmental
information labelling found on all packaged products.
Packing and unpacking
WARNING
Carefully store away all packaging because these ma-
terials are potential hazard for children.
To Next Page
Loading...
