Piranha Color Camera User’s Manual 26
DALSA 03-032-10211-01 5/9/2007
gsf get signal frequency i 1-4
h help
lfc load fpn coefficients
lfs load factory settings
lil load input lut
lpc load prnu coefficients
lus load user settings
rc reset camera
ril reset input lut
roi region of interest xx 1-2048:1-2048
rpc reset pixel coeffs
sab set add background ti 0-0:0-4095
sag set analog gain tf 0-0:-10.0-+10.0
sah set averaging horizontal i 1-2
sao set analog offset ti 0-0:0-255
sbr set baud rate m 9600/19200/57600/
115200/
scb select cable i 0-255
scc set colour correction iiii 0-+4095:-8192-
+8191:-8192-+8191:
-8192-+8191
scd set ccd direction i 0-2
scl set colour m rgb/r/g/b/
sdo set digital offset ti 0-0:0-4095
sem set exposure mode m 2/3/4/5/6/7/
sem set exposure mode m 2/3/4/5/6/7/
sfc set fpn coeff xi NA
sfr set fpn range xxi NA
sil set input lut tai NA
slt set lower threshold i 0-4095
smm set mirroring mode i 0-1
sot set output throughput m 30/40/60/80/
spc set prnu coeff xi NA
spr set prnu range xxi NA
srm set readout mode i 0-2
ssa set spatial alignment i 0-6
ssb set subtract background ti 0-0:0-4095
ssf set sync frequency f 1-32362
ssg set system gain ti 0-0:0-65535
ssn set set number i 0-5
sut set upper threshold i 0-4095
svm set video mode i 0-10
ugr update gain reference
vt verify temperature
vv verify voltage
wfc write FPN coefficients
wil write input lut
wpc write PRNU coefficients
wus write user settings
To Next Page
Loading...
General