Dalsa PC-30-02K80 - Writing and Loading Setting to Non-Volatile Memory

Piranha Color Camera User’s Manual 53
DALSA 03-032-10211-01 5/9/2007
 To write and load the FPN coefficients, use the wfc and lfc commands,
respectively.
 To write and load the PRNU coefficients, use the wpc and lfc commands,
respectively.
 Before issuing the user setting commands, select the set you wish to write using the
ssn command: Sets 1 to 4 are user sets.
Current Session Settings
These are the current operating settings of your camera. To save these settings to non-
volatile memory, use the command
wus.
Writing and Loading Setting to Non-Volatile Memory
Write User Settings
Purpose: Write all the current camera settings to the micro-controller’s
EEPROM.
Syntax:
wus
Syntax Elements:
Example:
wus
Notes: Before issuing this command, select the set you wish to write
with the ssn command:
Set 1-4 are user sets
The settings can be manually restored with using the lus
command.
The last saved set (excluding PC sets) of settings will be
restored automatically after the power is cycled or after the rc
command – this includes loading the LUT, FPN, and PRNU
with the saved set number
The format of the file sent to a PC is proprietary.
Related Commands:
Load User Settings
Purpose: Load the camera’s user settings from non-volatile memory and
send values to FPGA.
Syntax:
lus
Syntax Elements:
Example:
lus
Notes: Before issuing this command, select the set you wish to load
with the SSN command
0 = Factory set
1 to 4 = User sets
5 = Selects transfer from PC
Unlike LFS, LUS only restores the settings and not the FPN,
PRNU, and LUT.