Dalsa PC-30-02K80 - Camera Frequency Measurement; Returning the LED Status; Returning Camera Settings

Piranha Color Camera User’s Manual 63
DALSA 03-032-10211-01 5/9/2007
10%). The measurement should not be used to set the applied voltage to the camera but
only used as a test to isolate gross problems with the supply voltage.
Camera Frequency Measurement
Purpose: Returns the frequency for the requested Camera Link control
signal
Syntax:
gsf i
Syntax Elements:
i
Camera Link control signal to measure:
1: CC1 (EXSYNC/Blue PR)
2: CC2 (Green PR)
3: CC3 (CCD Direction)
4: CC4 (Spare/Red PR)
Note: Accuracy: ±271 ns
Reliable up to 40,000 H
Example:
gsf 1
Returning the LED Status
Purpose: Returns the status of the camera’s LED.
Syntax:
gsl
The camera returns one of the following values:
2 = green (camera is operating correctly)
5 = flashing green (camera is performing a function)
6 = flashing red (fatal error)
Notes:
• Refer to section
2.3 Camera LED for more information
on the camera LED
Returning Camera Settings
Returning All Camera Settings with the Camera Parameter Screen
The camera parameter (gcp) screen returns all of the camera’s current settings. The table
below lists all of the gcp screen settings.
To read all current camera settings, use the command:
Syntax:
gcp