Piranha Color Camera User’s Manual 67
DALSA 03-032-10211-01 5/9/2007
Syntax Parameters Description
get sao t Returns the analog offset for the tap indicated.
t = 0 for all taps or 1 to 4 for individual tap selection.
get sbr Returns the speed of camera serial communication port.
get scb Returns cable parameter.
get scc Returns current color correction coefficients.
get scd Returns the CCD shift direction selection where:
0 = Forward CCD shift direction.
1 = Reverse CCD shift direction.
2 = Externally controlled direction control via CC3.
get scl Return current color selection (rgb, r, g, or b)
get sdo t Returns the digital offset value in DN for the tap
indicated.
t = Tap value. 0 for all taps or 1 to 2 for individual tap
selection.
get sem Returns the current exposure mode:
2 = Internal SYNC, internal PRIN, programmable line
rate and exposure time using commands ssf and set
3 = External SYNC, maximum exposure time
4 = Smart EXSYNC
5 = External SYNC and PRIN
6 = External SYNC, internal PRIN, programmable
exposure time
7 = Internal programmable SYNC, maximum
exposure time.
get set Returns the current exposure time in µs.
get sfc x Returns the FPN coefficient for the pixel number
indicated.
x =pixel number within the range 1 to n, where n =
2048 or 4096 depending on the resolution.
get sfr x1 x2 Returns pixel range of FPN coefficients. x1 <
x2.
get sil t a Returns single LUT entry.
Only available when a single color is selected.
t = tap: 1 to 4
a = LUT address
get slt Returns the current lower threshold value. This
command depends on the color selected previously
using the scl command.
get smm Returns mirroring mode:
0: Off
1: On
get sot Returns output throughput in mega pixels per second
(mps) per color.
get spc x Returns the PRNU coefficient for the specified pixel
number.
This command is only available when a single color is
selected.
x=pixel number within the range 1 to n, where n =
2048 or 4096 depending on the resolution.
get spr x1 x2 Returns the pixel range of PRNU coefficients. x1 <
x2.
get ssb t Returns the current background subtract value.
t = Tap value. 0 for all taps or 1 to 4 for individual tap
selection depending on camera model.
get ssf Returns the current line rate in Hz. Only available while
To Next Page
Loading...