17. Hose Connector
The hose assembly is made up of a water inlet hose, a drain hose and a hose connector. The hose connector
fastens to the kitchen faucet by means of a faucet adapter. The hose connector also has a pressure relief button to
relieve pressure before disconnecting and allows water to be used in the sink while the dishwasher is operating.
PROCEDURE
Inspecting and replacing: Hose Connector
Step 1: Be sure all controls are Step 2:Inspect hoses for cracking or Step 3: Any leaks in the connector
turned OFF. Disconnect power deterioration. Disconnect and replace are resolved by replacing the hose
supply at distribution panel or as necessary. connector as an assembly.
unplug power cord from outlet.
watch for sharp edges.
Step 4: Replace washers in all
Leaking hose connections.
Reassemble dishwasher and
Check operation.
22
To Next Page
Loading...
