24
Fahrzeug-/Funktionsdecoder ab Firmware-Version 1.11
24
Locomotive/Locomotive function decoder from firmware version 3.12
Variants with interfaces:
5 In case your locomotive is equipped with a 12 pin interface (PluX12), you should take the decoder PD12A-4. They have
already the appropriate connections for this plug. The decoder can be inserted into the interface without any problem
now.
6
In case your locomotive is equipped with a 14 pin interface (mT
c14), you should take the decoder DH14B. It has already
the appropriate connection for this plug. The decoder can be inserted into the interface without any problem now.
7
In case your locomotive is equipped with a 16 pin interface (PluX16), you should take the decoder DH16A-
4. It has already
the appropriate connection for this plug. The decoder can be inserted into the interface without any problem now.
8 In case your locomotive is equipped with an 18 interface (Next18), you should take the decoder DH18A or PD18A.
It has already the appropriate connection for this plug. The decoder can be inserted into the interface without any
problem now.
9
In case your locomotive is equipped with a 21 pin interface (mtc21), you should take the decoder DH21A-
4, DH21A-5 or
PD21A-4. It has already the appropriate connection for this plug. The decoder can be inserted into the interface without
any problem now.
10 In case your locomotive is equipped with a 22 pin interface (PluX22), you should take the decoder DH22A-
4. It has already
the appropriate connection for this plug. The decoder can be inserted into the interface without any problem now.
BA DH engl FW3_12 Druck.indd 24BA DH engl FW3_12 Druck.indd 24 10.05.21 14:2710.05.21 14:27
To Next Page
Loading...
