36
Fahrzeug-/Funktionsdecoder ab Firmware-Version 1.11
36
Locomotive/Locomotive function decoder from firmware version 3.12
Notice to address range:
DCC operation allows only address values from 1 to 127 for DCC-CV01, operating MM values from 1 to 255 are allowed.
Values from 128 on lead to restricting the decoder operation only to MM, i.e. DCC operation is no longer possible. DCC
“service mode“ is of course still possible.
Activating the long DCC address through CV29/Bit5 makes vice versa that the decoder can be operated by DCC just now.
MM operation is no longer possible then. MM programming is also disabled. Attention “lock out“ is possible.
8.2 Setting options
The features of a locomotive operated in the DCC operating mode can be varied by programming the “Configuration
Variables“ (CV) freely at any time. The programming procedure is described in the instructions of your programming device.
Instructions for “Function Mapping“ by default see Doehler & Haass website:
https://doehler-haass.de/cms/pages/haeufige-fragen.php
Wie sieht das standardmäßige „Function Mapping“ aus? (only in German)
Notice:
In case the speed steps programmed on the decoder differ from those of the control device, malfunctions may occur.
Please pay attention to the information concerning your digital system.
BA DH engl FW3_12 Druck.indd 36BA DH engl FW3_12 Druck.indd 36 10.05.21 14:2710.05.21 14:27
To Next Page
Loading...
