Danfoss ADAP-KOOL Drive - Page 40

[33] t/min
[34] t/h
[40] m/s
[41] m/min
[45] m
[60] °C
[70] mbar
[71] bar
[72] Pa
[73] kPa
[74] m WG
[80] kW
[120] GPM
[121] gal/s
[122] gal/min
[123] gal/h
[124] CFM
[125] ft³/s
[126] ft³/min
[127] ft³/h
[130] lb/s
[131] lb/min
[132] lb/h
[140] ft/s
[141] ft/min
[145] ft
[160] °F
[170] psi
[171] lb/in²
[172] in WG
[173] ft WG
[180] HP
0-31 Custom Readout Min Value
Range: Function:
0 Custom-
ReadoutU-
nit*
[0 - 0 CustomReadoutUnit] This parameter allows the choice of the min. value of the custom defined readout (occurs at zero
speed). It is only possible to select a value different to 0 when selecting a linear unit in par.
0-30
Custom Readout Unit . For Quadratic and Cubic units the minimum value will be 0.
0-32 Custom Readout Max Value
Range: Function:
100.00 Cus-
tomReadou-
tUnit*
[par. 0-31 - 999999.99 CustomRea-
doutUnit]
This parameter sets the max value to be shown when the speed of the motor has reached the set
value for par.4-13
Motor Speed High Limit [RPM] or par.4-14 Motor Speed High Limit [Hz] (depends
on setting in par. 0-02).
3 Parameter Description ADAP-KOOL
®
Drive Programming Guide
40 MG.11.N1.02 - VLT
®
is a registered Danfoss trademark
3