EasyManua.ls Logo

Danfoss CF-MC - Mounting of CF-RS, -RP, -RD and -RF Room Thermostats; 5 Temperature Settings; CF-RS Room Thermostat; CF-RD and CF-RF Room Thermostat with Digital Display

Danfoss CF-MC
18 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation Guide CF-MC Master Controller
Danfoss Heating Solutions VIUHK902 01/2016
7
Initiate transmission test on Room Thermostat (fig. 27):
Press the push button , LED goes ON.
Satisfactory: LED goes OFF.
Not satisfactory: LED flashes 5 times.
No Link connection to Room Thermostat:
Try to relocate the Room Thermostat in the room.
Or install the CF-RU Repeater Unit and locate between the CF-MC Master Controller and the Room
Thermostat.
Note! CF-MC Master Controller output LED(s) connected to the Room Thermostat, flash(es) during Link
test.
4.13 Mounting of CF-RS, -RP, -RD and -RF Room Thermostats
Mount the CF-RS, -RP, -RD and -RF Room Thermostat sheltered from the sunlight and other sources
of heat (fig. 23).
Mount with screws (fig. 24):
Back plate.
Turning knob release (only available for CF-RS and -RD).
Back plate lock/unlock (turn 90°).
Screw hole for wall mounting.
Battery placement.
Screw and wall plug.
Note! Remove enclosed strips from batteries to activate.
A Room Thermostat can be assigned to several outputs if needed by repeating the installation process.
5. Temperature Settings
5.1 CF-RS and -RP Room Thermostat
Turning knob/cover (fig. 25):
Turning knob/cover release
CF-RS Room temperature limitation (fig. 26):
Minimum limitation (blue) (from 10 °C)
Maximum limitation (red) (up to 30 °C)
5.2 CF-RD and CF-RF Room Thermostat with Digital Display (fig. 21)
SET Set value adjustment
MIN Minimum temperature limitation
MAX Maximum temperature limitation
Transmission link icon
Low battery indicator
Alarm icon
Room temperature icon*
Floor temperature icon*
* Only valid for CF-RF Room Thermostat
Settings only available from CF-RC Remote Controller:
Lock icon
Timer icon
Cooling icon**
AUTO
Automatic change-over icon**
Heating icon**
** Only valid for CF-RD Room Thermostat. One of the standard CF-RD Room Thermostats can be defined
as a master thermostat for sequential control of heating and cooling stages, according to the room
temperature. This function is only available via CF-RC Remote Controller (see instruction for CF-RC).
GB

Other manuals for Danfoss CF-MC

Related product manuals