DEVIreg™ Opti
Installation Guide22
7 Settings & Break out
Room sensor or floor temperature
higher than max. 35°C
A “room only” option is also available,
but requires that you have to break
the small plastic seal on the the back
of the display module, e.g. using a
2. Twist
P09 and P10 are only accessible if Room and Floor is chosen
in P04 (temperature control mode).
* Only room temperate, possible only after break-out (see
next page).
** Max. temperature is 0,5°C below value set in P05.
To Next Page
Loading...
