Danfoss Heating
13
a) NEXT ON/OFF button to move to
the next setting,
b) + or - buttons to amend the time.
3. Press the PROG button twice to
return the unit to RUN mode (time
appears and colon in the display
begins to fl ash).
4. Proceed to page 14.
GB
DAY/HOL
DAY/HOL
1.8 Programming your Hot Water
To set the hot water programme press
the PROG button twice until SET HW ON
TIME appears on the display.
Set the hot water programme in the
same way as the heating programme,
using:
a) + and - buttons to alter the time,
b) Pressing the NEXT ON/OFF button to
move to the next setting,
c) Pressing DAY/HOL to advance
through days of the week (7 day
mode) or to advance to Saturday and
Sunday programming (5/2 day mode)
and repeat steps a-c.
DAY/HOL
DAY/HOL
DAY/HOL
DAY/HOL
To Next Page
Loading...
