User Guide | Intelligent Purging System (IPS 8) Ammonia
BC437120335698en-000101 | 6
© Danfoss | Climate Solutions | 2023.07
Basically, the IPS with the built-in MCX controller, only need one setting, How many Purge points?
See steps below for how to navigate to the parameter for entering how many Purge points which is
connected.
a) Navigate from the Main Menu to Start by <Enter>
b) Select “Main Switch OFF”
c) Go to Main Menu
d) Navigate from the Main Menu to “Login”
e) Enter password “200”
f ) Choose “Parameters”
g) Choose “Unit Cong”
h) Choose “Valve Settings”
i) Enter the number of purge solenoid valves connected to the IPS (factory setting is:8)
j) Go back to Start and chose ‘Main Switch ON’, and go back to main screen
See development below from left to right
IPS MCX controller – Quick
start
To Next Page
Loading...
Need help?
General
