4.3. Starting up the installation menu
• Remove the front cover of the Danfoss Link™ CC by gently
pulling it o, pull near the edges of the cover.
• Press the SETUP pin for 3 seconds to enter the service
area.
4.4. Mounting mains powered devices
Power-up all mains powered
devices rst, and any repeater units
that might be needed.
Note! If Danfoss Link™ HC is used, connect all actuators (TWA), before mains power-
ing the unit.ON/OFF relays are only visible in the end-user menu.
• Pair devices to Danfoss Link™ CC.
• Start with the device closest to the Danfoss Link™ CC,
and move outwards.
To Next Page
Loading...
