4. Technical settings
4.1 Reinstallation mode
If the thermostat has been removed from the radiator and needs
to be reinstalled (after being used), it is necessary to activate
installation mode to prevent damage to the thermostat.
To enter installation mode:
Press until M is displayed.
Press to withdraw the spindle. M ashes.
Reinstall the thermostat on the valve.
Press for approx. 3 seconds to exit.
Please also refer to section 6 regarding removal of the thermostat
from the radiator valve.
4.2 Testing the connection
Press for at least 3 seconds until M is displayed.
Press until LI is displayed.
Press to make the connection.
LI disappears when the connection is made.
If no connection can be made, the alarm and
antenna symbols ash together.
Refer to FAQ at
www.danfoss.com/living
To Next Page
Loading...
