3. Installation - step by step
3.3 Conguring Danfoss Link™ CC
For practical reasons, it is recommended that the Danfoss Link™ CC
is connected to a battery pack (014G0262). This makes the device
mobile, and it can then easily be positioned at a distance of up
to 1.5 m from each radiator thermostat that is to be added to
the system.
Remove the front cover from the Danfoss Link™ CC by carefully
levering it o, starting with the bottom corners. Press and hold
down the setup button using a ballpoint pen for approximately
three seconds to start the installation menu (the start-up phase
may take several minutes).
For Help, press ? in the lower right corner.
For installation without a battery pack, please see
www.danfoss.com/living
To Next Page
Loading...
