12 RS8FE102, 080R9278 © Danfoss A/S (RA Marketing/MWA), Nov. 08
OPTYMA
TM
Control three-phase Operation and Maintenance Guide
1.
Re-attach the front panel to the lower part of the
housing by inserting the two hinges in their seats.
Front panel connection
2.
Bend the hinges and rotate the front panel
downwards 180° to gain access to the inside of the
housing and then reconnect the electronic card
connector.
3.
When using Alarm/Aux relay, connect the wiring
directly to the electronic card clamps.
It is advisable to route these wires alongside the
connection cables from the electronic card and the
housing back panel.
Re-attach the front panel and reconnect the elec-
tronic card connector as shown below.
To Next Page
Loading...
