© Danfoss A/S (RA Marketing/MWA), Nov. 08 RS8FE102, 080R9278 15
OPTYMA
TM
Control three-phase Operation and Maintenance Guide
1.
Close the front panel, making sure that all the wires
are inside the housing and that the housing seal is
located securely in its seat
Closing the control
2.
Tighten the front panel using the 4 screws, making
sure the rubber washers are used on the head of
each screw.
Replace the screw cover on the right-hand side.
3.
Power up the control and carry out thorough reading/
programming of all the parameters.
Below is a step by step description on how to
calibrate the motor circuit breaker dedicated to the
compressor.
To Next Page
Loading...
