9
Before you start
Open the fl ap on the front of the
programmer.
Press the + & – AND & buttons
simultaneously to reset the unit.
This will reinstate the preset programmes
and will set the time to 12:00 on Day 1 and
the temperature to 20°C.
Setting the Clock & Day
Note: clock is displayed in 24 hour mode.
CLOCK
Press PROG to begin programming.
Use + or - to adjust the TIME (press and
hold to change in 10 min increments).
DAY
Press PROG again.
Use + or - buttons until correct DAY is
shown (1 = Monday, 2 = Tuesday, etc).
Remember - you will have to reset
the time when the clocks change in
Spring and Autumn.
i2 00
!
User Instructions
GB
To Next Page
Loading...
