Danfoss TP7000 Series User Manual

TP7000 RANGE
8
F
D
ES
DK
NL
I
GR
PL
LT
CZ
HR
GB
a) Press PROG until Event 1 fl ashes, then
press DAY to move from current day to
Day 1.
b) Amend the time and temperature as
follows:
i) Use + and – buttons to alter time
(press and hold to change in 10 min
increments).
ii) Use  and  buttons to alter
temperature in 0.5°C (1°F) steps.
iii) Press NEXT to advance to next
Event.
iv) Repeat steps i,ii & iii above for Events
2, 3, 4, 5 & 6.
c) When all 6 events are correct, press DAY
to programme events for Day 2.
1.81 Programming in 7-day mode
(separate programmes for each day of the week)
1
1
1 2 3 4 5
1.8 Before you change the preset programmes
Your installer will have set your unit to operate in either 7-day mode
or 5/2 day mode. To tell which mode your unit is set press PROG
until Event 1 fl ashes in the display.
This unit is in 7-day mode and you can programme
diff erent settings for each day of the week (see page
8-9).
This unit is in 5/2 day mode and you can enter one of
set of programmes for weekdays and another set for
weekends (see page 91).

Danfoss TP7000 Series Specifications

General

Type	Programmable Room Thermostat
Mounting	Wall-mounted
Switching Voltage	230 VAC
Protection Class	IP30
Programs	7-day programming
Display	LCD
Battery	2 x AA batteries
Power Source	Battery
Switching Current	3A (resistive)
Accuracy	±0.5°C