Danfoss VLT 2800 Quick Guide

1.2 Introduction
Use this Quick Guide to carry out quick and
EMC-correct installation of the frequency con-
verter in five steps.
Read the safety section before
installing the unit.
NB!
The Operating Instructions, MG.
27.AX.YY, give further examples
of installation and describe all
functions in detail.
The Design Guide, MG.
27.EX.YY, contains extensive in-
formation.
1.2.1 Abbreviations
ELCB Earth Leakage Circuit Breakers
NO Normally open
NC Normally closed
PD2 Dual phase (for 2822, 2840 that only run 3-phase as standard D2), 220 - 240 V
RCD Residual Current Device
1.2.2 Available Litterature
NB!
This quick guide contains only the very basic information necessary for installing and
running the drive.
For more information please consult the VLT 2800 Design Guide, MG.27.EX.YY
VLT 2800 Quick Guide 1 Quick Guide
MG.28.M1.02 - VLT
®
is a registered Danfoss trademark 3
1
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com

Danfoss VLT 2800 Specifications

General

Frequency	50/60 Hz
Enclosure	IP20
Input Voltage	200-240V AC
Output Power Range	0.37-2.2kW
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Communication Interface	RS485
Operating Temperature	-10°C to +40°C
Storage Temperature	-25°C to +65 °C
Relative Humidity	5 - 95% RH, non-condensing
Output Voltage	0 - 100% of supply voltage