Danfoss VLT AHF 005 Programming Guide

3.3.2 1-10 - 1-13 Motor Selection
NOTICE
This parameter group cannot be adjusted while the
motor is running.
The following parameters are active ('x') depending on
the setting of parameter 1-10 Motor Construction
Parameter 1-10 Motor
Construction
[0]
Asynchron
[1] PM Motor
non salient
Parameter 1-00 Conguration Mode
x x
Parameter 1-03 Torque Character-
istics
x
1-06 Clockwise Direction
x x
Parameter 1-14 Damping Gain
x
Parameter 1-15 Low Speed Filter
Time Const.
x
Parameter 1-16 High Speed Filter
Time Const.
x
Parameter 1-17 Voltage lter time
const.
x
Parameter 1-20 Motor Power [kW]
x
Parameter 1-21 Motor Power [HP]
x
Parameter 1-22 Motor Voltage
x
Parameter 1-23 Motor Frequency
x
Parameter 1-24 Motor Current
x x
Parameter 1-25 Motor Nominal
Speed
x x
Parameter 1-26 Motor Cont. Rated
Torque
x
Parameter 1-28 Motor Rotation
Check
x x
Parameter 1-29 Automatic Motor
Adaptation (AMA)
x
Parameter 1-30 Stator Resistance
(Rs)
x x
1-31 Rotor Resistance (Rr)
x
Parameter 1-35 Main Reactance (Xh)
x
Parameter 1-37 d-axis Inductance
(Ld)
x
Parameter 1-39 Motor Poles
x x
Parameter 1-40 Back EMF at 1000
RPM
x
Parameter 1-50 Motor Magneti-
sation at Zero Speed
x
Parameter 1-51 Min Speed Normal
Magnetising [RPM]
x
Parameter 1-52 Min Speed Normal
Magnetising [Hz]
x
Parameter 1-58 Flying Start Test
Pulses Current
x x
Parameter 1-59 Flying Start Test
Pulses Frequency
x x
Parameter 1-10 Motor
Construction
[0]
Asynchron
[1] PM Motor
non salient
Parameter 1-60 Low Speed Load
Compensation
x
Parameter 1-61 High Speed Load
Compensation
x
Parameter 1-62 Slip Compensation
x
Parameter 1-63 Slip Compensation
Time Constant
x
Parameter 1-64 Resonance
Dampening
x
Parameter 1-65 Resonance
Dampening Time Constant
x
Parameter 1-66 Min. Current at Low
Speed
x
Parameter 1-70 PM Start Mode
x
Parameter 1-71 Start Delay
x x
Parameter 1-72 Start Function
x x
Parameter 1-73 Flying Start
x x
Parameter 1-77 Compressor Start
Max Speed [RPM]
x
Parameter 1-78 Compressor Start
Max Speed [Hz]
x
Parameter 1-79 Compressor Start
Max Time to Trip
x
Parameter 1-80 Function at Stop
x x
Parameter 1-81 Min Speed for
Function at Stop [RPM]
x x
Parameter 1-82 Min Speed for
Function at Stop [Hz]
x x
Parameter 1-86 Trip Speed Low
[RPM]
x x
Parameter 1-87 Trip Speed Low [Hz]
x x
Parameter 1-90 Motor Thermal
Protection
x x
Parameter 1-91 Motor External Fan
x x
Parameter 1-93 Thermistor Source
x x
Parameter 2-00 DC Hold/Preheat
Current
x
Parameter 2-01 DC Brake Current
x x
Parameter 2-02 DC Braking Time
x
Parameter 2-03 DC Brake Cut In
Speed [RPM]
x
Parameter 2-04 DC Brake Cut In
Speed [Hz]
x
Parameter 2-06 Parking Current
x
Parameter 2-07 Parking Time
x
Parameter 2-10 Brake Function
x x
Parameter 2-11 Brake Resistor (ohm)
x x
Parameter 2-12 Brake Power Limit
(kW)
x x
Parameter 2-13 Brake Power
Monitoring
x x
Parameter 2-15 Brake Check
x x
2-16 AC brake Max. Current
x
Parameter Descriptions
VLT
®
HVAC Drive FC 102
38 Danfoss A/S © 03/2015 All rights reserved. MG11CE02
33

Danfoss VLT AHF 005 Specifications

General

Brand	Danfoss
Model	VLT AHF 005
Category	DC Drives
Language	English