Need help?Do you have a question about the Danfoss VLT AutomationDrive FC 361 N200 and is the answer not in the manual?
Defines warning, caution, and notice symbols used in the guide.
Defines qualifications for personnel installing or operating the equipment.
Provides critical safety warnings for high voltage and discharge.
Lists power ratings, weights, and dimensions for enclosures.
Describes features like short-circuit protection and overvoltage.
Explains protection against short circuits on motor and mains sides.
Details how the drive handles motor-generated overvoltage.
Describes detection of missing motor phases.
Explains detection of supply voltage imbalance.
Details torque, current, speed, and voltage limits.
Explains protection against locked rotor situations.
Describes automatic derating based on critical levels.
Explains AEO for maximizing efficiency.
Provides detailed electrical data for enclosures.
Specifies mains supply voltage, frequency, and drop-out behavior.
Details motor output voltage, frequency, and torque characteristics.
Lists environmental conditions like enclosure, humidity, and temperature.
Explains safe lifting procedures and warnings.
Details methods for reducing output current to avoid tripping.
Provides critical safety instructions for installation.
Illustrates the basic wiring schematic of the drive.
Details power and control cable connections.
Details control wiring practices and terminal assignments.
Lists recommended fuses and circuit breakers.
Provides instructions for EMC-compliant installation.
Shows wiring for open-loop speed control using analog references.
Illustrates wiring for start/stop commands.
Explains how to use the drive configurator and type code.
Guides on RS485 installation and setup.
Provides examples of writing and reading FC parameters.
To Next Page
General