No. Description Warning Alarm/Trip Alarm/Trip Lock Parameter
Reference
102 Too many CAN objects
103 Illegal axis num.
104 Mixing Fans
105 Error not reset
106 HOME not done
107 Home vel zero
108 Position error
109 Index not found
110 Unknown cmd.
111 SW end limit
112 Unknown param
113 FC not enabled
114 Too many loops
115 Par.save failed
116 Param. memory
117 Progr. Memory
118 Reset by CPU
119 User abort
121 No more SDO channels
125 HW end limit
149 Too many inter.
150 No ext. 24 V
151 GOSUB > limit
152 Return @ limit
154 D.out overload
155 LINK failed
156 Illegal double arg.
160 Internal Intr. error
162 Memory error
163 ATEX ETR cur.lim.warning X
164 ATEX ETR cur.lim.alarm X
165 ATEX ETR freq.lim.warning X
166 ATEX ETR freq.lim.alarm X
246 Pwr.card supply
250 New spare parts X
251 New Type Code X X
Table 7.1 Alarm/Warning Code List
(X) Dependent on parameter
1) Cannot be Auto reset via parameter 14-20 Reset Mode
Troubleshooting
VLT
®
Compressor Drives CDS 302/CDS 303
150 Danfoss A/S © Rev. 2013-07-03 All rights reserved. MG34M422
77
To Next Page
Loading...
Need help?
General