EasyManua.ls Logo

Danfoss VLT Micro Drive - Page 23

Danfoss VLT Micro Drive
31 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Input resistance, R
i
approx. 4k
Max. pulse frequency at terminal 33 5000Hz
Min. pulse frequency at terminal 33 20Hz
Analog Inputs
Number of analog inputs 2
Terminal number 53, 60
Voltage mode (Terminal 53) Switch S200=OFF(U)
Current mode (Terminal 53 and 60) Switch S200=ON(I)
Voltage level 0–10 V
Input resistance, R
i
approx. 10
Max. voltage 20 V
Current level 0/4 to 20 mA (scaleable)
Input resistance, R
i
approx. 200 Ω
Max. current 30 mA
Analog output
Number of programmable analog outputs 1
Terminal number 42
Current range at analog output 0/4-20 mA
Max. load to common at analog output 500 Ω
Max. voltage at analog output 17 V
Accuracy on analog output Max. error: 0.8% of full scale
Scan interval 4 ms
Resolution on analog output 8 bit
Scan interval 4 ms
Control card, RS-485 serial communication
Terminal number 68 (P,TX+, RX+), 69 (N,TX-, RX-)
Terminal number 61 Common for terminals 68 and 69
Control card, 24 V DC output
Terminal number 12
Max. load (M1 and M2) 100 mA
Max. load (M3) 50 mA
Max. load (M4 and M5) 80 mA
Relay output:
Programmable relay output 1
Relay 01 Terminal number 01-03 (break), 01-02 (make)
Max. terminal load (AC-1)1) on 01-02 (NO) (resistive load) 250V AC, 2 A
Max. terminal load (AC-15)
1)
on 01-02 (NO) (Inductive load @ cosφ 0.4) 250V AC, 0.2 A
Max. terminal load (DC-1)1) on 01-02 (NO) (resistive load) 30V DC, 2 A
Max. terminal load (DC-13)1) on 01-02 (NO) (inductive load) 24 V DC, 0.1A
Max. terminal load (AC-1)1) on 01-03 (NC) (resistive load) 250V AC, 2 A
Max. terminal load (AC-15)
1)
on 01-03 (NC) (Inductive load @ cosφ 0.4) 250V AC, 0.2A
Max. terminal load (DC-1)1) on 01-03 (NC) (resistive load) 30V DC, 2 A
Min. terminal load on 01-03 (NC), 01-02 (NO) 24V DC 10 mA, 24V AC 20 mA
Environment according to EN 60664-1 overvoltage category III/pollution degree 2
1) IEC 60947 part 4 and 5
Control card, 10 V DC output
Terminal number 50
Output voltage 10.5 V ±0.5 V
Max. load 25 mA
Quick Guide
VLT
®
Micro Drive Quick Guide
1-20 MG02B722 - VLT
®
is a registered Danfoss trademark
11

Other manuals for Danfoss VLT Micro Drive

Related product manuals