1.2 Introduction
1.2.1 Available Literature
This quick guide contains the basic information necessary for installing and running the drive.
If more information is needed, the literature below can be downloaded from:
http: //www.danfoss.com/BusinessAreas/DrivesSolutions/Documentations
Title Literature no.
VLT Micro Drive FC 51 Operating Instructions MG.02.AX.YY
VLT Micro Drive FC 51 Quick Guide MG.02.BX.YY
VLT Micro Drive FC 51 Programming Guide MG.02.CX.YY
FC 51 LCP Mounting Instruction MI.02.AX.YY
FC 51 De-coupling Plate Mounting Instruction MI.02.BX.YY
FC 51 Remote Mounting Kit Mounting Instruction MI.02.CX.YY
FC 51 DIN Rail Kit Mounting Instruction MI.02.DX.YY
FC 51 IP21 Kit Mounting Instruction MI.02.EX.YY
FC 51 Nema1 Kit Mounting Instruction MI.02.FX.YY
X = Revision Number, Y = Language code
1.2.2 Approvals
1.2.3 IT Mains
IT Mains
Installation on isolated mains source, i.e. IT mains.
Max. supply voltage allowed when connected to mains: 440 V.
As an option, Danfoss offers recommended line filters for improved harmonics performance.
1.2.4 Avoid unintended Start
While the frequency converter is connected to mains, the motor can be started/stopped using digital commands, bus
commands, references or via the Local Control Panel.
• Disconnect the frequency converter from mains whenever personal safety considerations make it necessary
to avoid unintended start of any motors.
• To avoid unintended start, always activate the [OFF] key before changing parameters.
1 Quick Guide Quick Guide for VLT Micro FC 51
2
MG.02.B5.02 - VLT
®
is a registered Danfoss trademark
1
To Next Page
Loading...
