1.4 Programming
1.4.1 Programming with LCP
For detailed information on programming, please see
Programming Guide
, MG.02.CX.YY.
NB!
The frequency converter can also be programmed from a PC via RS485 com-port by installing the MCT-10
Set-up Software.
This software can either be ordered using code number 130B1000 or downloaded from the Danfoss Web
site: www.danfoss.com/BusinessAreas/DrivesSolutions/softwaredownload
Illustration 1.7: Description of LCP buttons and display
Use the [MENU] key to select one of the following menus:
Status:
For readouts only.
Quick Menu:
For access to Quick Menus 1 and 2, respectively.
Main Menu:
For access to all parameters.
Navigation Keys:
[Back]: For moving to the previous step or layer in the
navigation structure.
Arrows [
▲
] [
▼
]: For manoeuvring between parameter
groups, parameters and within parameters.
[OK]: For selecting a parameter and for accepting
changes to parameter settings.
1 Quick Guide Quick Guide for VLT Micro FC 51
8
MG.02.B5.02 - VLT
®
is a registered Danfoss trademark
1
To Next Page
Loading...
