The illustration below shows all control terminals of the frequency converter. Applying Start (term. 18) and an analog
reference (term. 53 or 60) make the frequency converter run.
Illustration 1.5: Overview of control terminals in PNP-configuration and factory setting.
1.3.8 Power Circuit - Overview
Illustration 1.6: Diagram showing all electrical terminals.
* Brake (BR+ and BR-) are not applicable for frame M1.
1 Quick Guide Quick Guide for VLT Micro FC 51
6
MG.02.B5.02 - VLT
®
is a registered Danfoss trademark
1
To Next Page
Loading...
