Danfysik SYSTEM 9100 - Page 26

MAGNET POWER SUPPLY SYSTEM 9100
26
DANFYSIK A/S - DENMARK.
UART HW SET UP (Esc<BAUD)
In the “UART HW SETUP” mode the baud rate and associated parameters for the serial lines
can be set.
SW3 indicates witch line to set up.
Hint: Selecting SW3 will immediately display the present setting on the red LEDs below SW4.
SW3 FOR LOCAL LINE
SW3 FOR REMOTE LINE
ON ON
1
2 3
4
1
2
3
4
4
1
Parameters
PARITY
7 / 8 Bits
8 Bits
1½
2
7 Bits
STOP Bits
OFF
OFF
ON
ODD/EVEN
EVEN
ODD
BAUD
RATE
ON
1.200 2.400
9.600 19.200 38.400
57.600 76.800 115.200
1 2
3
4 5 6 7 8
SW4
Default setting after “COLD BOOT”
Local Line: 9600Baud, No party, 8 Bits, 2 Stop bits
Remote Line: 115200Baud, No party, 8 Bits, 1 Stop bits