Danfysik SYSTEM 9100 - 5 System 9100 Interface Specification; AC Mains Connector X1; Output X24 and X25

MAGNET POWER SUPPLY SYSTEM 9100
58
DANFYSIK A/S - DENMARK.
5 System 9100 Interface specification:
System 9100 has following external connection:
- Analog interface X108, D-sub 25 pole female
- REMOTE control Interface, D-sub 25 pole female
- LOCAL control interface, D-sub 9 pole female
- AC main input, 3 phase, Neutral and Earth and AC Control input
- Voltage output (+) X24, (-) X25
- MPS Status, 16-pol connector
- External trig (for use with Ramp), 16-pol connector
- External interlocks and polarity switch, 16-pol connector
- Connector for water cooling
- Fuse 2 A
AC Mains connector X1:
The power connector for 400VAC main and 230VAC control input
Pin no: Name I/O Description & Specification
1 NU
2 400 VAC 3-phase AC main input, L1
3 400 VAC 3-phase AC main input, L2
4 400 VAC 3-phase AC main input, L3
11 230 VAC Control input, Phase
12 230 VAC Control input, Neutral
Clips * Earth
*Two spring clips at the top and bottom of the connect
The power connector for 208VAC main and control input
Pin no: Name I/O Description & Specification
1 NU
2 208 VAC 3-phase AC main input, L1
3 208 VAC 3-phase AC main input, L2
4 208 VAC 3-phase AC main input, L3
11 208 VAC Control input, L1
12 208 VAC Control input, L2
Clips * Earth
*Two spring clips at the top and bottom of the connect
Output X24 and X25
Pin no: Name I/O Description & Specification
X24 O Positive polarity
X25 O Negative polarity