Danfysik SYSTEM 9100 - Introduction and Specifications; Specifications; Warranty and Warranty Repair

MAGNET POWER SUPPLY SYSTEM 9100
3
DANFYSIK A/S - DENMARK.
Table of contents PAGE
1 INTRODUCTION AND SPECIFICATIONS ....................................................................................... 5
1.1 GENERAL INTRODUCTION ............................................................................................................... 5
1.2 SPECIFICATIONS .............................................................................................................................. 6
1.3 WARRANTY AND WARRANTY REPAIR. ............................................................................................ 9
2 UNPACKING AND INSTALLATION............................................................................................... 10
2.1 RECEIVING THE GOODS ................................................................................................................. 10
2.2 INSTRUCTIONS FOR UNPACKING .................................................................................................... 10
2.3 INSTALLATION REQUIREMENTS ..................................................................................................... 10
2.4 INSTALLATION ............................................................................................................................... 11
2.5 RS422 OR RS485 MULTIDROP CONFIGURATION ........................................................................... 12
3 OPERATING INSTRUCTIONS ......................................................................................................... 13
3.1 SWITCHING ON .............................................................................................................................. 13
3.2 OPERATING WITH THE MANUAL CONTROL PANEL ....................................................................... 13
3.2.1 Main power ON / OFF and interlock RESET ...................................................................... 14
3.2.2 Using the Manual Panel Menus ............................................................................................ 14
3.2.3 Front panel controls. ............................................................................................................. 16
3.2.4 The Display .......................................................................................................................... 17
3.2.5 Control Menus ...................................................................................................................... 20
3.2.6 Current setting ...................................................................................................................... 22
3.2.7 Polarity reversal .................................................................................................................... 22
3.3 OPERATING BY RS 232, RS422 OR RS 485 I/O ............................................................................. 24
3.3.1 Setting up the MPS via display board .................................................................................. 24
3.3.2 Data communication ............................................................................................................. 36
3.3.3 Termination using RS 422m or RS 485................................................................................ 37
3.3.4 Programming ........................................................................................................................ 38
3.3.5 Software Profile Programming ............................................................................................. 39
3.3.6 Arbitrary point ramp profile method .................................................................................... 40
3.3.7 Equal time slot ramp profile method .................................................................................... 41
3.3.8 Auto Slew Rate Ramp Profile method. ................................................................................ 42
3.3.9 SW limits .............................................................................................................................. 43
3.4 OPERATING IN ANALOG MODE ...................................................................................................... 47
3.4.1 Standard interface / Parallel interface ................................................................................... 48
4 THEORY OF OPERATIONS .............................................................................................................. 49
4.1 INTRODUCTION .............................................................................................................................. 49
4.2 M-PANEL ....................................................................................................................................... 52
4.3 I-LOOP, CONTROL, INTERLOCK PCB ............................................................................................ 52
4.3.1 Micro-processor .................................................................................................................... 52
4.3.2 DAC Circuit ......................................................................................................................... 52
4.3.3 ADC Control ........................................................................................................................ 53
4.3.4 Voltage reference.................................................................................................................. 53
4.3.5 DC/DC Converter ................................................................................................................. 53
4.3.6 Seriel Interface...................................................................................................................... 53
4.3.7 Current & Voltage loop ........................................................................................................ 54
4.3.8 Control .................................................................................................................................. 54
4.3.9 Soft start ............................................................................................................................... 54
4.3.10 Interlock ................................................................................................................................ 54
4.3.11 Peltier Control ...................................................................................................................... 55