MAGNET POWER SUPPLY SYSTEM 9100
44
DANFYSIK A/S - DENMARK.
SW Commands
Following are the commands for the standard software listed in alphabetic order.
Please see the SW appendix 1 for detail explanation of every command.
STANDARD COMMANDS. Summary
X is a number from 0 to 9 and Commands in quotation marks are optional
AD X Read value from an ADC
channel.
ADR Read the address of the MPS.
ADR XXX Write an address to a MPS.
ANACTRL MPS Control by analog Set.
ASW Enters Answer mode
CMD Read current control mode.
CMDSTATE Read current control state.
CPUCTRL MPS Control by CPU DAC.
DA X,XXXXXX Writes a value to an Digital
to Analog converter.
(Alternative to the WA
command.)
ERRC Coded error message.
ERRT Text string error message.
F Main Power OFF
LALL Listen ALL.
LOC Change to Local Control
LOCK Lock the MPS in Local Control.
N Main Power ON
NASW No answer mode.
NERR No error message
PO Polarity status
PO +/- Change to Normal polarity
POLOOL Polarity Output Off Limit.
PRINT Reads internal user information
about the MPS.
RA Read the set value.
REM Change to remote control.
RLOCK Remote line only
RR Read Ramp speed.
RS Reset interlocks.
S1 Read the internal status.
S1H Read internal status in HEX
format
S1FIRST Read the interlock first catch status.
S1FIRSTH Read the interlock first catch status
in HEX format
S3 Read the internal extended
status.
S3H Read internal extended status in
HEX format
TD Test DAC
TYPE AD type in use
UNLOCK Unlock the MPS
VER Reads the software version
WA XXXXXX Writes a value to a Digital to
Analog converter.
(Preferred new command:DA 0)
WR Write Ramp speed
To Next Page
