2 | heating eleMents
The heating disk must be cleaned thoroughly to avoid
clogging and reduced rinsing performance.
Once per month or every 30 cycles
To access the heating disc, please remove the 3 filters(see page 62).
Then remove the protection part of the heating
disc and clean it.
You then have access to the heating disc, clean
it with a non-abrasive sponge in order to avoid
damaging (scratching) the non-stick coating.
Put the protection part back in place.
Then reinsert the 3 filters.
Once a week or every 10 cycles
Turn the microfilter counter-clockwise to unlock
the microfilter/coarse filter combination.
Warning: Never start a cycle without the filters in place.
If your microfilter is damaged, please contact Daan Tech
service (page 73).
Additionally, lift out the stainless steel filter.
Rinse the 3 filters under running tap water and
clean them with a soft bristle brush
Now reinsert the micro filter/coarse waste filter
combination by turning it clockwise until it clicks
to ensure its correct position.
Put the stainless steel filter back into Bob.
63
QUICK MAINTENANCE GUIDE
62
QUICK MAINTENANCE GUIDE
To Next Page
Loading...