29 • Mini dap4 User Manual
The following will be displayed (values are for reference only):
▼ Press the ENTER key to advance to Comp Short Cycle. The cursor will ash on the current selection. Press the
UP or DOWN keys to change the selection.
Available Selections:
Comp Short Cycle: YES or NO
Note: With the setting in the YES selection mode, a compressor short-cycle alarm will activate and if the compressor
has energized ten (10) times in a one (1) hour period.
Compressor life can be shortened by allowing frequent cycling. On-going short-cycle alarm problems should ana-
lyzed before selecting NO.
Once a selection has been made, press the ENTER key to advance to Reset Alarm Log. The cursor will ash on the
current selection.
Reset Alarm Log: YES or NO (feature not used – see section on clearing alarms on page 42)
Note: The factory setting is NO. If YES is selected, the selection will change to NO once the cursor is returned to the
title block and the alarm history is cleared.
Once a selection has been made, press the ENTER key to advance to Alarm Contact Screen. The cursor will ash on
the current selection.
The available selections for Alarm Screen Contact are: Alarm Screen Contact: No Contact Message
Service Company
Maint Engineer
Data Proc Mngr
Custom Message (factory installed option)
Once a selection or selections have been made, move the cursor to the title block (Alarm Settings) by pressing the
ENTER key
▼ Press the DOWN key to view the next screen:
The following will be displayed (values are for reference only):
Alarm Settings
Comp Short Cycle: Yes
Reset Alarm Log: No
Alarm Screen Contact:
no Contact Message
Flow Alarm
No Water Flow Action:
Alarm Only
Wtr Flow Alm Dly: 5s
Air Flow Alm Dly: 5s
To Next Page
Loading...
Need help?
General
