To Next Page

To Previous Page

SD Series Installation and Administrator’s Guide 61

Hopper 1 Settings

Usethefollowingsettingstospecifyvaluesforcardspickedfromhopper1.Setup

hopper1forthemostcommonlyusedcardtype.

Hopper1DebowSettings:

• Hopper1DebowDirection—Setthedirectionofthedebowactioninthe

laminatortoreturnthecardtoitspropershapeafteranoverlayisapplied.A

cardmaybecomebowedslightlyinaconcaveorconvexshapeduetoheat

fromthelaminator.

• Down—Thedebowarmsinthelaminatorpressdownonthecard.

• Up—Thedebowarmspressuponthecard.

• Hopper1DebowDistanceDown—Settheamount(distance)tomovethe

debowarmsdown.Thevalueisinincrementsofthedebowmotor.(Thisvalue

isusedwhenHopper1DebowDirectionissettoDown.)

• Increasethevaluetobendthecarddownmore.

• Decreasethevaluetobendthecarddownless.

• Hopper1DebowDistanceUp—Settheamount(distance)tomovethedebow

armsup.Thevalueisinincrementsofthedebowmotor.(Thisvalueisused

whenHopper1DebowDirectionissettoUp.)

• Increasethevaluetobendthecardupmore.

• Decreasethevaluetobendthecardupless.

• Hopper1DebowDwellMs—Setthetime,inmilliseconds,thedebowactionis

appliedtoacard.Thedefaultis2000ms(2seconds).

• Increasethevaluetoapplythedebowactionlonger.

• Decreasethevaluetoapplythedebowactionforlesstime.

Hopper1ImpresserSettings:

• Hopper1ImpressDepth—Setthedepthoftheimpressiononacard.Thevalue

isinstepsoftheimpresserpunch.

• Increasethevaluetodeepentheimpression.

• Decreasethevaluetolessentheimpression.

Youmayneedtoadjustthecardimpressdepthvaluebasedonthecard

materialandoverlaytypeused.

DataCard SD260LTM Installation And Administration Guide

Other manuals for DataCard SD260LTM