Powering Up
WARNING
The power cord supplied with the unit must be used.
Use this simple procedure to start using your Datacolor 110™.
1. Verify all cable connections. The AC power cord should be plugged into an outlet. The
instrument cable should be attached to the instrument and host computer.
2. Turn on the host computer.
3. Turn on the power switch. It is the red switch on the back of the instrument.
− When power is applied, all mechanisms are automatically reset.
− The red lights on the status panel will flash. They should stop flashing within 30
seconds.
NOTE
If the instrument power is not turned on before a Datacolor program is launched,
you may receive an error message.
4. When the Ready light remains on, your instrument is ready to use.
5. Launch a Datacolor program.
18 • Powering Up Datacolor 110 User's Guide
To Next Page
Loading...