Datalogic Applications
106 DL-Axist™
Doing this will not undo settings changes already made, but it will
prevent DXU from getting the device’s settings and will prevent DXU
from changing any settings on the device.
b. Enable Discovery Manager
This check box controls the DL-Axist’s broadcast of its name and
device type over USB or over a network to the DXU desktop
application. When selected, DXU will automatically see when the
device connects to USB or over a network. When cleared, DXU will not
display when the device connects to USB or over the network. This
check box is selected by default.
c. Enable Log
This check box enables DXU Agent’s logging capability. When
enabled, logs are written to the log file location. Logging can be
helpful when diagnosing problems, but at a slight cost of slowing
DXU and consuming slightly more power. This check box is not
selected by default.
d. Change Log File Location
This field allows you to specify where DXU Agent’s log file is kept on
your device. The default location on Android OS devices is
/storage/sdcard0, which is located in the device’s on-board flash
memory. This location is a persistent location, so log files stored here
are safe if the device reboots. If a MicroSD card is used, you may wish
to specify that logs be kept on the card if the card has greater
capacity than on-board flash. MicroSD cards are also persistent.
e. Allow Binary Data in Configuration
This check box allows a few types of binary data to be transmitted
from the DL-Axist to DXU, and from DXU to the DL-Axist. The desktop
wallpaper file is an example of binary data that can be controlled by
DXU. Selecting this check box allows binary data to be sent to or from
the binary computer in the configuration file. Clearing this check box
To Next Page
Loading...
Need help?
General
